Currently out of stock
Over $39.99
Returns
Warranty
- 22,000 LB CAPACITY: Heavy-duty rubber supports cars, SUVs, trucks, and service vehicles on suitable surfaces.
- DUAL CABLE CHANNELS: Two built-in channels route and protect cords, hoses, or pipes beneath vehicle traffic.
- HIGH-VISIBILITY SURFACE: Reflective strips and textured tread improve visibility and tire contact.
- 7 FT MODULAR LENGTH: The 84.65-inch section provides wide coverage for parking lots and access lanes.
- QUICK INSTALLATION: Pre-drilled holes and included mounting hardware simplify secure placement.
Description
GARVEE
7 FT Heavy-Duty Rubber Speed Bump
Manage vehicle speed and protect temporary cables with a 22,000 lb load capacity, dual underside channels, reflective visibility strips, and a durable 84.65-inch rubber design.
Heavy-Duty Rubber Construction
The flexible rubber body absorbs repeated vehicle contact while supporting cars, SUVs, trucks, and service vehicles on suitable surfaces.
Integrated Cable Protection
Two underside channels create a protected route for extension cords, hoses, pipes, and temporary utility lines.
High-Visibility Driving Surface
Reflective strips and textured tread make the ramp easier to identify while providing added tire contact.
Wide Coverage for Controlled Traffic Areas
The 84.65-inch ramp creates a noticeable transition across vehicle paths, helping encourage reduced driving speeds in parking lots, private roads, garages, warehouses, and loading areas.
- 22,000 lb capacity: supports common passenger and commercial vehicles when properly installed.
- 7 FT nominal length: provides broad coverage across driveways and access lanes.
- Textured tread surface: increases contact between vehicle tires and the rubber ramp.
- Reflective visibility strips: make the ramp easier to notice during daytime and low-light use.
- Non-folding construction: provides a stable single-piece traffic-control section.
Dual Channels for Cables and Hoses
Route temporary electrical cords, water hoses, pipes, and utility lines underneath the ramp to reduce direct contact with vehicle tires.
Pre-Drilled for Easier Installation
Pre-drilled mounting holes and included hardware help simplify installation. Use anchors that are appropriate for the selected mounting surface.
Suitable for Multiple Traffic-Control Locations
Use the rubber speed bump in properly prepared residential, commercial, and industrial vehicle areas.
Specifications
| Pack Quantity | 1 Piece |
|---|---|
| Overall Dimensions | 84.65" × 11.81" × 1.97" |
| Nominal Length | 7 FT |
| Load Capacity | 22,000 lb |
| Main Material | Heavy-Duty Rubber |
| Cable Channels | 2 Integrated Channels |
| Installation | Pre-Drilled Mounting Holes with Hardware |
| Item Weight | 55.12 lb |
| Color | Black |
Installation and Use Note
- Install the speed bump on a clean, level, and structurally suitable surface.
- Select anchors that match the concrete, asphalt, or actual mounting substrate.
- Confirm that cables and hoses fit completely inside the channels before allowing vehicle traffic.
- Do not exceed the rated 22,000 lb load capacity.
- Inspect the rubber body, reflective strips, mounting holes, and hardware regularly.
- Check applicable property and local traffic-control requirements before installation.